1.

1. Make sure gas is turned off and the damper clamp provided is on the fireplace damper. Then place the H-Burner in the middle of the fireplace.

2.

1. Connect elbow fitting on gas pipe. Make sure you use two pipe wrenches when installing the elbow, one on the elbow and one on the pipe. Make sure the pipe from the fireplace does not turn. Use gas tape to place on the male threads.

3.

1. Connect the flared connection to the burner. Use gas tape on the male side of the burner.
   

4.

1. Connect the flex line provided to the gas burner. No tape is needed.

5.

1. Connect the flex line to the elbow fitting. Gas tape is not needed.
   

6.

1. Tighten both sides with a pipe wrench.
   

7.

1. The burner is now completely connected to the house gas. Light the burner to test for leaks.
   

8.

1. Open Fire Glass bags and pour glass over the burner and on the fireplace floor.
   

9.

1. Re-light the burner to test for even flame and to assure the flame is in the right position.
   

10.

1. Step back and watch while the flames dance on the glass!